Table of Contents
Advertisement
Port Type (for Analog Trunked Radio)
Procedure 21-7 How to Configure the ACE3600 Port for the Astro IV&D Analog Radio
1.
In the ACE3600 STS click on the desired site, and open the site view.
2.
In the Port Tab, click on the plug-in port through which the RTU will communicate with
the XTL5000/XTL2500 radio.
3.
Set the port parameters as shown in the screen below. The Trunk system parameter
should reflect the type of trunking system (e.g. SmartNet, SmartZone.)
Note: XTL2500 trunking mode supports DPSK modulation only.
4.
Save the changes.
Figure 21-7 RTU Site Configuration for MDLC over Analog Trunked System – Port Type
Port Type (for Analog Conventional Radio)
Procedure 21-8 How to Configure the ACE3600 Port for the Astro IV&D Analog Convetional
Radio
1.
In the ACE3600 STS click on the desired site, and open the site view.
2.
In the Port Tab, click on the plug-in port through which the RTU will communicate with
the XTL5000/XTL2500 radio.
3.
Set the port parameters as shown in the screen below.
Note: XTL2500 trunking mode supports DPSK modulation only.
4.
Save the changes.
Figure 21-8 RTU Site Configuration for MDLC over Analog Conventional System – Port Type
Programming the XTL5000/XTL2500 Analog Trunked and Conventional Radio using CPS
The XTL5000/XTL2500 radio is programmed for ACE3600 in the factory and is ready for
analog trunked/conventional communication. For user programming of site-specific
parameters, the radio should be brought to the Motorola Service Center.
Parameters
Parameters
21-14
Radio Types and Installation Kits
Advertisement
Table of Contents
