Table of Contents
Advertisement
FHN7007A) on the signal cable (FKN8438A) near the bottom of the CPU door, loop the
cable one turn around it, and clamp the ferrite on the cable.
Connect the other end of the communication cable to the ACE3600 CPU module port
configured for the radio. (See Figure 21-2 and Figure 21-4.) For digital mode use any of
the serial on-board or plug-in ports. For analog mode only the plug-in ports may be used.
See RTU Port Configuration for the Astro IV&D Digital Radio and RTU Port
Configuration for the Astro IV&D Analog Trunked Radio below.
4.
Connect the DC power cable (FKN8436A) to the Power connector on the radio and the
free red wire to the ignition pin on the FKN8432A/FKN8438A cable. Connect the
opposite end of the power cable to the AUX2A or AUX2B connector on the ACE3600
power supply unit. (See Figure 21-2 and Figure 21-4.)
XTL5000/
XTL2500
Radio
Radio Mounting
Screws
(
#0310906A67)
Figure 21-1 XTL5000/XTL2500 Radio and Metal Bracket
21-6
Radio Types and Installation Kits
Radio
Mounting
Screws
(
#031096A67)
Radio
Bracket
(
#0789422V41
)
Advertisement
Table of Contents
