Programming A Circle With Known Radius - Siemens SINUMERIK 828D Operating Manual

Parameter
Y
I
J
F
PL
8.5.9

Programming a circle with known radius

The tool traverses a circular path with the programmed radius from its actual position to the
programmed circle end point. The control system calculates the circle center point. You do
not need to program interpolation parameters.
The circle can only be traversed at machining feedrate.
Procedure
Parameter
Direction of rotation
X
Y
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
Description
Target position Y (abs) or target position Y referred to the last programmed
position (inc)
Distance between circle starting point and center point in X direction (inc.)
Distance between circle starting point and center point in Y direction (inc.)
Machining feedrate
Plane: The circle is traversed in the set plane with the relevant interpolation
parameters:
XYIJ: XY plane with interpolation parameters I and J
ZXKI: ZX plane with interpolation parameters K and I
YZJK: YZ plane with interpolation parameters J and K
1. The ShopMill program to be edited has been created and you are in
the editor.
2. Press the menu forward key and the "Straight Circle" softkey.
3. Press the "Circle radius" softkey.
Description
The tool travels in the programmed direction from the circle starting point to its end
point. You can program this direction as clockwise or counterclockwise.
Clockwise direction of rotation
Counterclockwise direction of rotation
Target position X (abs) or target position X referred to the last programmed
position (inc)
Target position Y (abs) or target position Y referred to the last programmed
position (inc)
Programming technological functions (cycles)
8.5 Further cycles and functions ShopMill
Unit
mm
mm
mm
mm/rev
mm/min
mm/tooth
mm
mm
mm
Unit
mm
mm
325