Execution in manual mode
3.6 Simple face milling of workpiece
3.6
Simple face milling of workpiece
You can use this cycle to face mill any workpiece. A rectangular surface is always machined.
Selecting the machining direction
In the "Direction" field, using the select key, select the desired machining direction:
● Same direction of machining
● Alternating direction of machining
Selecting limits
You can select the limits using the appropriate softkeys:
See also
Face milling (CYCLE61) (Page 238)
Prerequisite
To carry out simple stock removal of a workpiece in manual mode, a measured tool must be
in the machining position.
Procedure
116
Left
Bottom
Top
Right
1.
Select the "Machine" operating area.
2.
Press the <JOG> key.
3.
Press the <Face milling> softkey.
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
HMI sl Milling