Siemens SINUMERIK 828D Operating Manual page 134

Machining the workpiece
4.7 Starting machining at a specific point
You must enter the target in the line of the window corresponding to the program level in
which the target is located.
For example, if the target is located in the subprogram called directly from the main program,
you must enter the target in program level 2.
The specified target must always be unambiguous. This means, for example, that if the
subprogram is called in the main program in two different places, you must also specify a
target in program level 1 (main program).
Procedure
Note
Interruption point
You can load the interruption point in search pointer mode.
134
1. Press the "Block search" softkey.
2. Press the "Search pointer" softkey.
3. Enter the full path of the program as well as the subprograms, if
required, in the input fields.
4. Press the "Start search" softkey.
The search starts. Your specified search mode will be taken into
account.
The Search window closes. The current block will be displayed in the
"Program" window as soon as the target is found.
5. Press the <CYCLE START> key twice.
Processing is continued from the defined location.
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
HMI sl Milling