Deactivate handwheel
2.11
MDA
In "MDA" mode (Manual Data Automatic mode), you can enter G-code commands block-by-
block and immediately execute them for setting up the machine.
You can load an MDA program straight from the Program Manager into the MDA buffer. You
may also store programs which were rendered or changed in the MDA operating window into
any directory of the Program Manager.
2.11.1
Loading an MDA program from the Program Manager
Proceed as follows
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
1.
Position the cursor on the handwheel whose assignment you wish to
cancel (e.g. No. 1).
2.
Press the softkey for the assigned axis again (e.g. "X").
- OR -
Open the "Axis" selection box using the <INSERT> key, navigate to
the empty field, and press the <INPUT> key.
Clearing an axis selection also clears the handwheel selection (e.g.,
"X" is cleared for handwheel no. 1 and is no longer active).
1.
Select the "Machine" operating area.
2.
Press the <MDA> key.
The MDI editor opens.
3.
Press the "Load MDA" softkey.
A changeover is made into the Program Manager.
The "Load in MDA" window opens. The program manager is displayed
in it.
Setting up the machine
2.11 MDA
101