Chapter 14 – Communications
3
Direct Communication Using the Electrical Ethernet Port
1 – White / green stripe
2 – Green solid
3 – White / orange stripe
4 – Blue solid
5 – White / blue stripe
6 – Orange solid
7 – White / brown stripe
8 – Brown solid
Figure 100: Local communication with equipment using the electrical Ethernet port architecture
RPV311-TM-EN-7
For local communication with equipment using the electrical Ethernet port, connect a
crossover 10/100BaseT Ethernet cable, with RJ45 connector, between the computer
and the equipment, as shown in
have the following pinout:
568 A
In local communication with the equipment, it is necessary that the device and the
computer be on the same network. To achieve this, configure the network
connection of the computer according to the IP address, Broadcast and Netmask of
the equipment, as shown below:
Given the following IP address, broadcast and netmask of the RPV311:
Figure 100
The crossover Ethernet cable should
568 B
3 – White / orange stripe
6 – Orange solid
1 – White / green stripe
4 – Blue solid
5 – White / blue stripe
2 – Green solid
7 – White / brown stripe
8 – Brown solid
RPV311
209