Groups; Figure 38: Steady-State Recorder - Flicker Configuration Section - GE RPV311 Technical Manual

RPV311
15

Groups

RPV311-TM-EN-7
Figure 38: Steady-state recorder – flicker configuration section
A The I
DENTIFIER
B The T field shows the circuit type.
YPE
C The check box allows the selection of circuits to be included in the steady-state
record.
In the flicker recorder, up to 6 circuits can be selected at the same time.
Group setup allows the user to monitor voltage and current circuit information via
local interface or the Monitoring screen at the web interface operation.
It is not possible to monitor circuits that are not included in either group.
To add new groups fill in the following:
The I

DENTIFIER
defined (maximum 15 characters). No editing allowed;
 The I
DENTIFIER
 The T
The check box allows user to include the preset circuits for the group

formation;
 The <D
The <S

The L

line characteristics (length and impedance), for the fault location.
The RPV311 uses one-end impedance fault location based on the Takagi algorithm
field shows all the voltage circuits previously configured.
text field allows user to enter a single code for the group being
field shows all the circuits and channels previously configured;
field shows the circuits type;
YPE
> button allows user to deselect all circuits marked;
ESELECT ALL
> button allows user to select all circuits;
ELECT ALL
, R0, X0, R1 and X1 text fields allow user to enter the transmission
ENGTH
Chapter 4 – Configuration
85