Appendix J LED Inspection Checksheet
If you cannot monitor status using NEC Storage Manager, the LEDs in the unit can be used to check on
LED status. If errors are detected, report the status indicated with an underline and the differing LED
status to expedite the identification of the abnormality source and the arrangements for its repair.
For more details, see
Section 1.2.3: "LED
J.1 Disk Array Unit
(1) ID LED (Blue)
(2) SERVICE LED (Orange)
(3) POWER LED (Green)
(4) STANDBY LED (White)
(5) ACTIVE/FAULT LED (Green/Orange)
PS0
(1) INPUT GOOD LED (Green)
(2) FAULT LED (Orange)
(3) SERVICE ACTION LED (Blue)
(4) DC GOOD LED (Green)
(5) STANDBY GOOD LED
(Green)
PS1
(1) INPUT GOOD LED (Green)
(2) FAULT LED (Orange)
(3) SERVICE ACTION LED (Blue)
(4) DC GOOD LED (Green)
(5) STANDBY GOOD LED
(Green)
Release 6.0
Display".
Table J-1: Disk Array Unit - Front
On · Blinking · Off
On · Blinking · 4-sec On, 8-sec. Off · 1-sec On, 1-sec Off · Off
On · Blinking · 0.2-sec On, 0.2-sec Off · Off
On · Blinking · Off
On · Blinking · Off / On · Blinking · Off
On · Blinking · Off / On · Blinking · Off
On · Blinking · Off / On · Blinking · Off
Table J-2: Disk Array Unit - Back
On · Off
On · Off
On · Off
On · Off
On · Off
On · Off
On · Off
On · Off
On · Off
On · Off
431
Location ( )
Location ( )
Location ( )