Figure 4-13: Starting Network Setting Tool - NEC Storage M100 Series User Manual

User Guide
10.Click Next to start Network Setting Tool.
11.Proceed to configuration of IP addresses of the disk array. See
Addresses by Using Network Setting
Configure the IP addresses of the disk array during the installation. The IP addresses consist of the IP
addresses of controllers, BMC addresses of controllers and a floating address. If NEC Storage
Manager Client is used, an IP address should be set to each of controllers.
A BMC address is a communication port to be used to link NEC Storage Manager with
ESMPRO/AutomaticRunningController (ESMPRO/AC).
When the installation is started from by selecting Setup for M series in Storage Manager
Setup, JRE and .NET Framework, which are necessary for Network Setting Tool and NEC
Storage Manager Client (Web GUI), must be installed.
Release 6.0

Figure 4-13: Starting Network Setting Tool

Tool".
105
Chapter 4 NEC Storage Manager
Section 4.3.2: "Configuring IP