Toro Groundsmaster 3505-D Service Manual page 89

Removal (Fig. 36)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
WARNING
Before jacking up the machine, review and follow
Jacking Instructions in Chapter 1 - - Safety.
2. Jack up front of machine enough to allow the removal
of the front wheel. Support machine with jack stands or
blocking.
IMPORTANT: DO NOT hit wheel hub, wheel hub
puller or wheel motor with a hammer during removal
or installation. Hammering may cause damage to
the wheel motor.
3. Remove tire and wheel assembly, wheel hub and
brake drum from the hydraulic motor. Remove brake as-
sembly, brake bracket and wheel shield from the frame
(see Front Wheel and Brake Removal in the Service and
Repairs section of Chapter 6 -- Chassis).
4. Thoroughly clean hydraulic hose ends and fittings on
wheel motor to prevent hydraulic system contamination.
Groundsmaster 3505--D
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
5. Remove wheel motor from frame using Figure 36 as
guide.
Installation (Fig. 36)
1. Install wheel motor to frame using Figure 36 as
guide.
2. Install wheel shield, brake bracket and brake assem-
bly to the frame. Install brake drum, wheel hub and
wheel assembly to the hydraulic motor (see Front Wheel
and Brake Installation in the Service and Repairs sec-
tion of Chapter 6 -- Chassis).
3. Lower the machine to the ground.
4. Make sure hydraulic tank is full. Add correct oil if nec-
essary (see Traction Unit Operator's Manual).
Page 4 - - 59
WARNING
Hydraulic System