Toro Groundsmaster 3505-D Service Manual page 177

Disassembly (Fig. 8)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Remove control panel cover from the machine.
IMPORTANT: When removing the adjustable clevis
from either the brake pivot shaft or adjustment rod
or the brake lever from the cam shaft on the brake
assembly, make sure to matchmark both parts.
Marking both parts will make assembly and brake
adjustment easier.
3. Remove parts as necessary using Figure 8 as a
guide.
Groundsmaster 3505--D
Assembly (Fig. 8)
1. Assemble components as necessary using Figure 8
as a guide.
2. Install control panel cover to the machine.
IMPORTANT: Always check and adjust brakes any-
time brake linkages are disassembled or repaired.
3. Adjust brake linkages (see Adjust Brakes in the Ad-
justments section).
Page 6 - - 13 Chassis