Specifications - Toro Groundsmaster 3505-D Service Manual

Specifications

MOUNTING: All cutting units are supported by equal
length, independent lift arms and are interchangeable to
all three cutting unit positions.
CONSTRUCTION: Deck chamber is welded 7, 10 and
12 gauge steel. Deck frame is welded 1--1/2 inch square
tubing with 7 gauge side supports.
HEIGHT- -OF- -CUT RANGE: 3/4 to 4 inch (1.9 to 10.2
cm) in 1/4 inch (6.4 mm) increments. Height--of--cut ad-
justment is made by repositioning deck on deck frame.
DECK DRIVE: Closed loop, integrated relief, hydraulic
system operates cutting deck hydraulic motors. Blade
spindles are 1--1/4 inch shafts supported by greaseable,
tapered roller bearings.
CUTTING BLADE: Each cutting unit equipped with 27
inch (68.6 cm) length, .25 inch (6.4 mm) thick, heat
treated, steel blade. Anti--scalp cup installed on cutting
blade.
Cutting Units
DISCHARGE: Clippings are discharged from the rear of
the cutting deck. Pre--drilled mounting holes allow at-
tachment of optional mulching baffle.
CUTTING UNIT LIFT: Cutting units are controlled with
one lever.
SUSPENSION SYSTEM: A fully floating suspension
with hydraulic counterbalance. Individual decks sup-
ported with two front rollers and one, full width, rear roll-
er.
WEIGHT: Complete cutting unit weighs 210 lb (95 kg).
Page 7 - - 2 Groundsmaster 3505--D