Yamaha 2012 TMAX XP500A Service Manual page 97

1. Right handlebar switch
2. Front brake master cylinder
3. Right handlebar switch lead
4. Front brake hose (front brake master cylin-
der to hydraulic unit)
5. Rear brake hose (rear brake master cylin-
der to hydraulic unit)
6. Left handlebar switch lead
7. Rear brake master cylinder
8. Left handlebar switch
9. Rear brake lock cable
10.Front brake pipe/joint assembly
11.Horn lead
12.Lead holder
13.Cap bolt cover
14.Front brake hose (hydraulic unit to front
brake hose joint)
15.Throttle cables
16.Handlebar
A. Route the right handlebar switch lead in
front of the throttle cables and through the
upper bracket forward.
B. Route the left handlebar switch lead in
front of the rear brake lock cable and
through the upper bracket forward.
C. Pass the brake pipe between the projec-
tions.
D. Install the rear brake hose so that the yel-
low paint mark on the pipe faces to the
front of the vehicle.
E. Route the rear brake lock cable behind the
handlebar switch leads and throttle cables.
F. Pass the brake hoses through the guide
wire.
G. Route the throttle cables behind the han-
dlebar switch leads and front of the rear
brake lock cable.
H. Install the front brake hose so that the
white paint mark on the pipe faces to the
front of the vehicle.
I. Connect the wire harness of the front and
rear brake switch connectors from inside
the vehicle.
J. Install the brake pipe against the projec-
tion.
K. Install the rear brake lock cable after rotat-
ing the rear brake lock lever to the position
shown in the illustration.
L. Apply YAMAHA GREASE "F" to the end of
the rear brake lock cable and install it.
2-42
CABLE ROUTING