Yamaha 2012 TMAX XP500A Service Manual page 444

Diag-
nostic
code
No.
d:61 Malfunction history code
display
• No history
• History exists
d:62 Malfunction history code
erasure
• No history
• History exists
d:63 Malfunction code reinstate-
ment (for fault code No. 24)
• No malfunction code
• Malfunction code exists
d:70 Control number
Set the main switch to "OFF" to cancel the diagnostic mode.
TIP
Information about each diagnostic code No. is organized in this manual as follows:
• If a diagnostic code No. has a corresponding fault code No., the information is shown in TROU-
BLESHOOTING DETAILS. (Refer to "TROUBLESHOOTING DETAILS" on page 8-37)
• If a diagnostic code No. does not have a corresponding fault code No., the information is shown in
DIAGNOSTIC CODE TABLE. (Refer to "DIAGNOSTIC CODE TABLE" on page 8-68)
Item Meter display/Actuation
00
Fault code Nos. 12–50
• (If more than one code
number is detected, the dis-
play alternates every two
seconds to show all the
detected code numbers.
When all code numbers are
shown, the display repeats
the same process.)
00
• Displays the total number of
malfunctions, including the
current malfunction, that
have occurred since the his-
tory was last erased. (For
example, if there have been
three malfunctions, "03" is
displayed.)
00
Fault code No. 24
0–254 [-]
FUEL INJECTION SYSTEM
8-69
Procedure
—
—
To erase the history, set the
engine stop switch from
" " to " ".
—
To reinstate, set the engine
stop switch from " " to
" ".
—