Yamaha 2012 TMAX XP500A Service Manual page 192

• When installing the rear brake caliper bracket
and the rear wheel sensor housing, align the
projection "c" on the rear brake caliper
bracket with the slot "d" of the rear wheel
sensor housing.
• After installing the rear wheel to the vehicle,
make sure that the projection "e" on the
brake caliper bracket and the projection "f"
on the rear wheel sensor housing are
aligned.
• Install the left adjusting block so that projec-
tion "g" faces to the front of the vehicle.
• Install the right adjusting block so that upper
chamfer "h" faces to the top of the vehicle
and lower chamfer "h" faces to the bottom of
the vehicle.
A. Left side
B. Right side
5. Install:
• Rear brake caliper
• Rear brake lock caliper
(temporarily)
6. Adjust:
• Drive belt slack
Refer to "ADJUSTING THE DRIVE BELT
SLACK" on page 3-21.
7. Tighten:
• Wheel axle nut
• Rear brake caliper bolts
• Rear brake lock caliper bolts
Wheel axle nut
160 Nm (16 m·kgf, 116 ft·lbf)
Rear brake caliper bolt
27 Nm (2.7 m·kgf, 20 ft·lbf)
Rear brake lock caliper bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
EWA13500
WARNING
Make sure the brake hose is routed prop-
erly.
TIP
When tightening the wheel axle nut, there
should be no clearance "a" between the adjust-
ing block "1" and adjusting bolt "2".
4-35
REAR WHEEL