Test Print; Correct Use Of The System - ABB HTP500 User Manual

For this reason it is recommended to observe the instructions listed below:
Store plates in plastic bags to protect them from dust and dirt.

Place plates on a flat surface to prevent them from bending or warping.

Store plates at a temperature from 0°C to 40°C, and 10% to 85% RH. Temperatures

higher than these ones, even for a short time, will cause plates to bend or warp.
Don't leave plates in the car.


7.6 TEST PRINT

The test print can be performed by the printer without using the PC.
1) Turn on the printer
2) Load an item
Use an item at least 60mm wide and 100mm long.
3) Execute a test print following the steps below
Press Online to put the printer offline (the Online led turn off)
Press [Menu/ ]
Press [Menu/ ] and [ ] to select Test Print
Press Enter to confirm
Press [Menu/ ] and [ ] to select, among the 6 kinds of material available in the printer Menu,
which is the material of the item loaded in the printer
Press Enter to confirm your choice
4) The printer begins to print the print test on the item and then ejects it

7.7 CORRECT USE OF THE SYSTEM

Follow carefully the instructions for the correct HTP500 V2 printer utilization:
1) Only items supplied by ABB and tested for the HTP500 V2 can be used.
2) Before to insert an item into the printer, verify that it is flat with no curve.
3) Before to insert an item into the printer, verify that the item's surface has no dirt, dust, steel
or what else that might compromise the head functioning.
4) In the case that the HTP500 V2 printer gets blocked, utilize only the "REMOVE" function
from the control panel to take off the item. Never take off the blocked item with force. This
operation might compromise the printer functioning.
5)Never modify the initial resistant value set by the supplier. This operation might
compromise the right head functioning.
6)To obtain the best print quality set correctly the HTP500 V2 printer depending on the
different item's typologies (as in the instructions of this user's guide). A non correct setting
doesn't allow to obtain the best print quality and might compromise the correct head
functioning.
7)Do not try any fixing, tampering; utilize only original accessories and spare parts.
REMIND