Loading / Removing The Cleaning Cassette - ABB HTP500 User Manual


Make sure to use a printer cable IEEE-1284 of lenght under 2mt so to avoid any kind of
disturbs or radio interference.
This equipment has been tested to comply with EMC Directive technical requirements. Shielded
cables have to be used in compliance with EMC Directive technical requirements.

2.4 LOADING / REMOVING THE CLEANING CASSETTE

2.4.1 Loading of the Cleaning Cassette
HTP500 V2 has a special cleaning cassette purposely designed to clean up the cleaning
roller.
To load the cleaning cassette perform the following steps:
1) Lift up the cassette cover.
2)Take out the ribbon cassette.

Never use the printer without the cleaning cassette. Using the printer when the cleaning roller
is dirty can damage the print head.

Before loading the cleaning cassette, take out the ribbon cassette. Trying to load the cleaning
cassette while the ribbon cassette is still in his place, could cause a bad cleaning cassette
loading
3) Lower the setting lever. The cleaning roller will raise.
4) Open the new cleaning cassette pulling out the tape untill the cleaning tape comes out.
Peel off the tape.
CAUTION
NOTICE
NOTICE
Lower the setting lever
Auxiliary Cleaning
Roller will rise
Peel Off the tape