Preparing Of The Support Plate - ABB HTP500 User Manual


Do not tight too much the locking screw A so not to damage it. Do not loosen too much the
docking screw A but just enough to fix the guides.

4.3 PREPARING OF THE SUPPORT PLATE

Execute all the described operations with the Printer turned off.
Take the SUPPORT PLATE and pass it through the CARD STORE till its mobile part reaches the
position indicate in the picture:
Make sure to have positioned correctly the CARD STORE so that it will be well fixed to the screw A
and rest on the guides.
WARNING
To prints in automatic MODE, always make sure to utilize the correct SUPPORT PLATE.
Pick up 2 modules of cable tags and insert it in the Card Store.
B
NOTICE
REMIND
Push the lever on the left
underneath the screw A