Turning On The Printer - ABB HTP500 User Manual


If the width guides are too close together, the plate will not be feed properly. It is important to adjust the
width guides so that the plate is not loose but it moves smoothly to the left. If the width guides are too
loose, the plate will be fed not straigth, yielding poor print results.

Always make sure the guides are properly aligned with the plate.
3) Tighten the locking screw securing the width guides in the right position.

Don't tighten the locking screw too much. Don't loosen the locking screw too much, only enough to
adjust and fix the guides in the proper position.
4) Insert the plate into the feed opening until the printer beeps.
When printing more than one plate, before loading another plate, wait until the printer
ejects the previous plate and beeps and until the message PRINTING disappears from the
display At this stage you can load the next plate
.

6.3 TURNING ON THE PRINTER

Turning On The Printer.
On the display will be visualized the message
PLEASE WAIT...
VERSION X.X
REMIND
NOTICE
REMIND
and afterwards the message
PRINT READY
PLATE SBLACK