ABB HTP500 User Manual page 56

1) Press [Menu/ ]
2) Press [Menu/ ] and [ ] to display "Auto Off"
3) Press ENTER
4) Press [Menu/ ] and [ ] to change selection (off to delete the option, later 5min, later
10min, later 30min)
5) Press ENTER to confirm
BACKLIGHT
Function for the definition of the brightness of the Printer LCD Panel.
1) Press [Menu/ ]
2) Press [Menu/ ] and [ ] to display "Backlight"
3) Press ENTER
4) Press [Menu/ ] and [ ] to change selection (1 darker, 5 lighter)
5) Press ENTER to confirm
AUTO CLEANING - Changing the cleaning roller timer for cleaning
AUTO CLEANING Function
This function is optional and must be set according to the environmental conditions.
The User sets the timing for the automatic cleaning of the cleaning roller.
The cleaning interval is set in terms of printed length (NO, 500, 1000, 2000, 5000 mm).
If the cleaning roller quickly becomes dirty, the interval should be reduced on the contrary if
the cleaning roller stays clean, the cleaning interval can be lengthened.
1)Press [Menu/ ]
2)Press [Menu/ ] and [ ] to display Auto Cleaning
3)Press Enter and [Menu/ ] and [ ] to select NO or 500, 1000, 2000, 5000 mm after
4)Press Enter to confirm
CLEANING – Cleaning of the cleaning roller
CLEANING Function
Select Cleaning to clean the cleaning roller. This function removes debris from the cleaning
roller preventing therefore any eventual printing problem.
1)Press [Menu/ ]
2)Press [Menu/ ] and [ ] to display Cleaning
3)Press Enter to confirm
TEST PRINT
Select this function to make a test print without using the PC.
The test print confirms that the printer is ready to print.
REMOVE – Removing a plate in of jammed Item
Select this function to remove a plate from the printer:
1)Press [Menu/ ]
2)Press [Menu/ ] and [ ] to display Remove
3)Press Enter to confirm
4)Press [Menu/ ] and [ ] to Move the Jammed Item Left or Right.