Functions; Operation; Engine Status Sheet; Reset Counter - Epson AcuLaser C1900 Service Manual

EPSON AcuLaser C1900/AcuLaser C900

5.3.2.2 Functions

This service utility can execute the following functions:
"Printer" information
Name of the printer connected ("AcuLaser C900")
"Communication Mode" information
Displays the interface connected
• Nibble (parallel interface)
ECP (parallel interface)
•
• USB
• I/F Card (Type-B / Network I/F)
"Printer Firmware" information
Firmware version currently installed
"Engine Firmware" information
Mechanical controller firmware version currently installed

"Engine Status Sheet"

Prints the engine status sheet.

"Reset Counter"

Initializes the counters for the Regularly Replaced Part and After-Sales Service
Parts whose lives are controlled by the printer. The parts for which the counter
must be initialized are as follows:
"Fuser" (Main Fuser Assembly: Regularly Replaced Part)
"USB ID"
Registers the ID number for the USB interface in EEPROM on the Main Board.
Adjustment

5.3.3 Operation

5.3.3.1 Engine Status Sheet
Click the [Status Sheet] button to print the engine status sheet.
Since the paper size supported is only A4, set A4 size paper in the
C H E C K
P O I N T printer.
When the engine status sheet is being printed, the process control (Cycle Up / Cycle
Down process control) of the engine will be forcedly carried out.
5.3.3.2 Reset Counter
When you have replaced any of the Regularly Replaced Part and After-Sales Service
Parts specified above, be sure to reset the relevant counter.
Once you have executed resetting, you can never undo the
C H E C K
P O I N T resetting. To warn you not to execute resetting carelessly, the
confirmation screen as shown below will be displayed when the
[Execute] button for Reset Counter has been clicked. Click [OK]
to execute initializing the counter or click [Cancel] to terminate
the service utility without executing resetting.
Service Utility (AcuLaser C900)
Revision B
215