Details Of Warning Status And Remedy - Epson AcuLaser C1900 Service Manual

EPSON AcuLaser C1900/AcuLaser C900
NOT ENOUGH PRINTER MEMORY TO PRINT USING DUPLEX FUNCTION
(STATUS CODE: 3004)
Description
Because of insufficient memory, data for the front page (the second side of duplex)
is not saved.
The Continue command of the ESCPAGES-02 protocol clears the error, and
printing resumes from the next combination of front/back.
When "Avoid Error = ON" is set, the printer displays the "Print Failure" error
status instead of this error, and resumes printing the next combination of front/
back.
Remedy
To print pages after the memory error, select [Continue] in the EPSON Status
Monitor.
To reprint after modifying the driver settings, select [Cancel Printing] in the
EPSON Status Monitor.
OPTIONAL INTERFACE CARD ERROR (STATUS CODE: 4014)
Description
An interface card that cannot be used is installed.
Since the printer looks for interface cards only when it is turned on, this error does
not recover while the printer is powered on.
Only interface cards compatible with expanding background job commands are
supported.
The printer does not receive data only. Therefore, it is possible to display this
status in the EPSON Status Monitor or updating the Type-B firmware.
Remedy
Turn off the printer, remove the invalid interface card, and then turn it on again.
Troubleshooting

3.3.5 Details of Warning Status and Remedy

ONLY ONE SHEET PRINTED (STATUS CODE: 2013)
Description
Band data of pages for multi-copying is not saved for one page entirely.
The ResetFlag command of the ESCPAGES-02 protocol clears this warning.
In some cases, this warning status occurs before data for one page is completely
sent; however, continuing to send the data prints only one sheet.
Remedy
This warning occurs only when a flying start is performed, and since data is resent
(number of copies n - 1) times, this warning status is not displayed in the user
interface.
PRINTING ON INCORRECT PAPER SIZE (STATUS CODE: 2004)
Description
The size of the paper actually fed is different from the paper size recognized by the
paper size detection method of the Paper Source setting (or the paper size in the
MP tray specified by data).
The ResetFlag command of the ESCPAGES-02 protocol clears this warning.
This warning does not occur when the specified paper size is an undefined paper
size, and when "Size Ignore = ON" is selected.
Remedy
Clicking the [Close] button closes the pop-up message of the EPSON Status
Monitor. However, if an error of higher priority occurs just after that, the display
changes to the error display. From this point, error handling is applied, and the
status never goes back to the "Check Paper Size" warning.
PRINT QUALITY DECREASED (STATUS CODE: 2002)
Description
Because of insufficient printer memory, printing is performed with non-reversible
compression. The printer does not process non-reversible compression, but
transmitted data is already compressed nonreversible.
The ResetFlag command of the ESCPAGES-02 protocol clears this warning.
Status Display (AcuLaser C900)
Revision B
156