Programming Feature Keys - Samsung DCS Manual

3.42 PROGRAMMING FEATURE KEYS

Allows the System Administrator to customise the programmable keys on specific keysets on the DCS
system. Buttons 1 and 2 are set as CALL buttons by default. Features are entered via the dial pad key
by pressing the dial pad number the required steps to select the feature. For example, for OHVA the
number 6 is pressed three times. If a BOSS key is required, press 2 for the first letter B, and then use the
UP or DOWN key to change selection from BARGE to BOSS.
COUNT →
DIAL 2
DIAL 3
DIAL 4
DIAL 5
DIAL 6
DIAL 7
DIAL 8
* On the DCS 70 this is HDSET
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPEAKER
HOLD
ACTION
1. Press TRSF 722
Display shows
2. Enter selected station number (eg., 205)
OR press UP or DOWN key to select
station number and press RIGHT soft key
to move cursor
3. Enter selected key number (eg., 18) OR
press UP or DOWN key to select key
number and press the RIGHT soft key to
move the cursor
4. Using above chart press the dial pad key
number to make selection OR press the
UP or DOWN key to make selection
and press RIGHT soft key to move
the cursor to step 5 to enter extender
if required or to return to step 2
5. If required, enter extender (eg., 03) OR
Press UP or DOWN key to make
selection Press RIGHT soft key to
return to step 2
Page 41
DIAL KEYPAD
1 2
AAPLAY BARGE
DICT DICT
GPIK HLDPK*
LCR LCR
MMPA NEW
PAGE PAGE
TG UA
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next program
Used to clear previous entry
3 4
CALL
FAUTO
IG
LCR
OHVA
REJECT SETMG
VDIAL
DISPLAY
[201] KEY PROG.
01 : CALL 1 →
[205] KEY PROG.
01 : CALL 1 →
[205] KEY PROG.
18 : NONE → _
[201] KEY PROG.
18 : NONE → GPIK_
[201] KEY PROG.
18 : NONE → GPIK 03