Forced Account Codes; Authorisation Codes; Using The Tieline - Samsung DCS Manual

1.12 FORCED ACCOUNT CODES

Account codes are used to provide accountability for the calls that are made. These account codes can
be either forced or optional; if forced, they are always verified from a system list of up to 500 entries.
1.12.1 USING FORCED ACCOUNT CODES
• Lift the handset and press the ACCT CODE key or dial 47.
• Enter the account code.
• Press the account code button again, then press TRSF (or hookflash on an standard telephone).
If a correct code is entered, you will hear DCS dial tone and you can make an outside call in the usual
manner. If an incorrect code is entered, the station returns error tone.
For information on entering and changing forced account codes, see the System Administrator
programming section of this book.

AUTHORISATION CODES

1.13
Authorisation codes are used to validate a station user and give permission to make a call. These four
digit authorisation codes can be either forced or optional; if used, they are always verified from a
system list of up to 250 entries.
Each authorisation code has an associated class of service. When the code is entered, the class of
service is changed to the dialling class of the authorisation code.
1.13.1 USING AUTHORISATION CODES
After going off-hook, you must dial * followed by a four digit authorisation code. If you enter a correct
code, you will hear a confirmation tone and then receive DCS dial tone and you can make an outside
call in the usual manner. The station then follows the dialling class for that authorisation code. If you
enter an incorrect code, the station returns error tone. This code may or may not print on SMDR reports
depending on SMDR programming.

1.14 USING THE TIELINE

OUTGOING
Your office can be connected to another system with a tieline. Use this line to make calls to
stations in the other system. If programming allows, you can access lines in the other system to make
outside calls. Tieline calls can be put on hold, transferred and conferenced in the same manner as
other outside calls.
• Lift the handset or press the SPEAKER key.
• Dial the tie line access code or press the tie line key.
• When you receive dial tone from the other system, you can dial extension numbers or access
outside lines. You must know the extension numbers and the line access codes for the other system.
• Finish the call by replacing the handset or pressing ANS/RLS key.
•
NOTE: Outgoing calls are controlled by the station's dialling class.
Page 4