Setup For Auto-Test, Auto-Arm And Opening/Closing Times - GE NX-10 Installer Manual

Data
1 Fire alarm
2 24 hour alarm
3 Trouble alarm
4 Tamper alarm
5 Yelping siren
6 Steady siren
7 Any siren
8 Any bypass
9 AC fail
10 Low battery
11 Duress
12 Aux 1 keypad (fire alarm)
13 Aux 2 keypad (medical alarm)
14 Panic keypad
15 Keypad tamper
16 Autotest
17 Alarm memory (solid)
18 Entry
19 Exit
20 Entry or exit
21 Armed state
22 Disarmed state
23 Ready
24 Not ready
25 Fire
26 Fire trouble
27 Chime
28 Expander trouble
29 Dynamic battery test time
Notes:
♦
When event 48 is programmed, it is possible to program a user code authorisation to select the
output(s), which a particular code will activate.
♣
Events 49 and 50 require one or more of the following to operate: wireless receivers or
cardreaders.
If set to follow condition, these events will be 1 second.

Setup for auto-test, auto-arm and opening/closing times

LOCATION 51 - AUTOTEST CONTROL (4 segments, numerical data)
Segment 1 Program a "1" if the interval is to be in hours; program a "0" for days. Add a "2" to
suppress the daily test or a "3" to suppress the hourly test if any report has been
sent
Segment 2 Program the autotest interval from 1-255 hours/days
Segment 3 Program the autotest report hour in 24 hour format (if the interval is in hours, this
segment Is ignored)
Segment 4 Program the autotest report time, number of minutes after the hour
Event Data
48♦
49♣
50♣
Event
31 Closed period
32 Listen-in
33 Line seizure
34 Reserved
35 Fail to communicate
36 Telephone line fault
37 Program mode
38 Download in process
39 Reserved
40 Short circuit (overcurrent on 12 V DC)
41 Box tamper
42 Siren tamper
43 Any open
44 Any short
45 Any fault (open/short on non-fire zone)
46 Any alarm
47 Beeping keypad
Code entry (see note below)
Key FOB function 1
Key FOB function 2
51 Always ON
52 Autoarm warning time
53 Any siren when in away mode
54 Progress of entry/exit (follows keypad
buzzer)
55 Auxiliary communication failure
56 Radio test
57 Any siren when armed in any mode
58 Alarm memory (pulsating)
59 Zone inactivity
NX-10 Installers manual
105