GE NX-10 Installer Manual page 195

Report type
TCP/IP reporting
Up/downloading over GSM
Up/downloading over GPRS
Voice channel
Information
Menu Option
required
TCP/IP Alarm Port Select NX-7002 Module>Options>Network>Port Numbers>TCP/IP
Alarm Port.
This should match the port number on the receiver side.
Status Check Select NX-7002 Module>Options>Status Check>GSM Connection>GPRS
Connected.
Destination Select NX-7002 Module>Reporting>Report Control>Report
n>Destination>TCP/IP 1 or 2.
IP address Select NX-7002 Module>Reporting>TCP/IP
Reporting>Receivers>Receiver n>IP Address.
Account Code Select NX-7002 Module>Reporting>TCP/IP
Reporting>Receivers>Receiver n>Account Code.
Note:
Receiver Number Select NX-7002 Module>Reporting>TCP/IP
Reporting>Receivers>Receiver n>Receiver Number.
Line Number Select NX-7002 Module>Reporting>TCP/IP
Reporting>Receivers>Receiver n>Line Number.
Protocol Select NX-7002 Module>Reporting>TCP/IP Reporting>Report
Format>SIA.
Enable Polling Select NX-7002 Module>Reporting>TCP/IP Reporting>Polling Time.
GSM Data Phone Select NX-7002 Module>Up/Download>Phone Number.
Number
Note:
Allow Calls from Select NX-7002 Module>Up/Download>Allow Calls From.
Note:
Connection Type Select NX-7002 Module>Up/Download>Connection Type>CSD.
GPRS IP address Select NX-7002 Module>Up/Download>IP Address.
Note:
U/D Port Select NX-7002 Module>Options>Network>Port Numbers>U/D Port.
Connection Type Select NX-7002 Module>Up/Download>Connection Type>TCP/IP.
Phone Number Select Installer Menu>Control Panel>System Settings>Feature
Select>Miscellaneous> Use GSM If Line Trouble
Note:
NX-10 Installers manual
SIA account numbers are 6 digits long. Contact ID account
numbers are 4 digits long. Add leading zeros to create an 8-
digit number.
Use the DL900 version that supports GSM downloading.
Only allows incoming data calls from specific phone
numbers.
Use the DL900 version that supports GPRS downloading.
This can only be used when the phone line monitor is
enabled on the panel.
If you want to use the Voice over GSM as the primary means
of reporting, program a '10' in front of the phone number.
Use the latest panel software. All programming is done via
the panel.
195