GE NX-10 Installer Manual page 82

Location Term
2.5.1.2.3 Bypass
2.5.1.2.3.1 Auto Bypass
2.5.1.2.3.2 Code Required
2.5.1.2.3.3 Sounder Alert
2.5.1.2.3.4 Bypass Toggle
2.5.1.2.3.5 No Force Bypass
2.5.1.2.4.1 Mains/Batt Sounder Alert
2.5.1.2.4.2 Tamper if Zone Lost
2.6 System Settings
2.6.1 Timers
2.6.1.1 Zones
2.6.1.1.1 Fire Verification Time
2.6.1.1.2 Zone Inact. Unit
2.6.1.1.3 Zone Activity Monitor
Definition
to work on a particular keypad in the particular partition.
When the user sets the LED Extinguish option for the
Control Panel to Enable then he must restart power supply
for the control panel. After restarting, this function will be
enabled.
When the user wants to disable this option he must set it to
Disable, and restart the power supply. The system then
waits for a valid user code. The LED Extinguish option gets
disabled after the user enters the user code (for example,
arm the system, accept an alarm, enter the user menu,
etc.).
To temporarily remove a zone from operation when arming
the system.
A menu entry that groups bypass options.
A menu option that automatically bypasses interior
follower zones if no exit is detected during the exit delay
time. The exit is detected by the opening and closing of an
entry/exit zone.
A menu option that specifies whether a user code is
required for bypassing zones.
A menu option that activates the keypad buzzer when a
user arms the system with one or more zones bypassed.
A menu option that allows an interior zone be bypassed or
included while the system is armed.
A menu option that disables auto bypassing of force
armable zones.
A menu option that causes the keypad sounder to beep
upon arming or disarming if the mains power is missing or
a low battery is detected.
A menu option that sends a report to the central station
when a wireless zone sensor is lost and activates a tamper
alarm. Different reports are sent depending on the system
status. When armed the tamper and the lost report are
sent. When disarmed only the lost report is sent.
A menu entry that groups programmable system features
and reporting options.
A menu entry that groups timer options.
A menu entry that groups time settings relating to zones.
A menu option that sets the amount of time within which a
second trip must occur on a smoke detector in order to
generate an alarm.
A menu option that allows the zone inactivity option to be
configured in hours or days.
A menu option that sets the zone inactivity time. It is
possible to specify this time in minutes or hours.