Cub Cadet 3000
The spool/sleeve assembly may be removed from the
control valve housing in either the vertical or horizon-
tal position.
VERTICAL POSITION
Carefully reposition the control valve assembly in the
vertical position with the meter end of the control
valve housing pointing upward. Remove the
spool/sleeve assembly from the control valve housing.
IMPORTANT: Do not bind the spool/sleeve assembly
in the control housing.
Rotate the spool/sleeve assembly slightly and slowly
when removing from the control housing.
HORIZONTAL POSITION
Rotate the spool/sleeve assembly until the cross pin
is horizontal with the porting face flange. Position the
control valve assembly with the porting face on a
clean flat surface.
Remove the spool/sleeve assembly from the metering
section end of the control housing keeping the cross
pin in the horizontal position.
IMPORTANT: Do not bind the spool/sleeve assembly
in the control housing.
Rotate the spool/sleeve assembly slightly back and
forth when removing from the control housing.
Figure 14.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Using a small screwdriver or similar type tool, remove
the cross pin from the spool/sleeve assembly.
Figure 15.
Push or pull the spool forward to remove it from the
sleeve.
NOTE: Caution must be used not to dislodge the
spring retaining ring during removal of the spool from
the sleeve.
Figure 16.
6 - 4