1999 3000 Series Engineering Updates; Heat Shield; Check Valve; Seat Improvements - Cub Cadet 3000 Series Service Manual

1999 3000 Series Engineering Updates

HEAT SHIELD

A heat shield has been installed on all 3000 series
tractors for 1999. The heat shield prevents the
exhaust gases from browning the grass. Use kit #759-
3927. See Service Advisory CC-371.
Heat Shield
1. Remove both of the hex bolts and lock nuts
securing the front bumper to the frame using a
3/4" socket and a 3/4" wrench.
2. Remove the bumper.
3. Slide the muffler shield over the exhaust pipe and
rotate it into position.
NOTE: Align all three holes in the top of the
muffler shield with the existing shield. Also, the
muffler shield will be slanting towards the bottom
of the front grill assembly.
Heat Shield
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
4. Secure the muffler shield with three sheet metal
Sheet Metal Screws
Mark used in
5. Install the bumper.
LIFT LINK
The lift link has been modified by strengthening the
powder metal that connects the lift lever to the
hydraulic valve for 1999.

CHECK VALVE

For 1999, a check valve will be installed to the
hydraulic valve to prevent the decks and other attach-
ments from leaking down during and after usage.
LIFT STOP BRACKET
A lift stop bracket will be installed on the left hand side
of the deck to prevent the deck from hanging up dur-
ing operations. Use kit #759-3927.
ROLLER HEIGHT ADJUSTER
The rear roller height adjustment mechanism will be
changed for 1999. A newly designed detent pin will
replace the old one, preventing the loss of cutting
height during operations. Use kit #759-3928.
FRONT DECK HANGER ASSEMBLY
The front roller bracket has been redesigned to pre-
vent the front lift rod from detaching during operation.

SEAT IMPROVEMENTS

A safer seat spring, part number 732-0869, can be
installed to level the seat for petite operators. In addi-
tion, the seat part number 757-3010A, is now made
out of a softer material for better operator comfort.
See Service Advisory CC-358A Sections 5 and 6.
FRONT MOWER DECK HEIGHT ADJUSTER
The front mower deck height adjuster pins have been
changed from ball detent pins to quick pull pins.
2 - 1
screws.
NOTE: Use a long flat blade screwdriver through
the air holes in the grill to tighten the sheet metal
screws securely.
Screwdriver
Production
to Test PTO
Activation
Cub Cadet 3000
Grill