Position - Cub Cadet 17AF4BFP009 Operator's Manual

Hydro Transmission Bypass Rods
The hydro transmission bypass rods are located inside
and behind the tractor's front wheels. When engaged,
these levers open a hydro pump bypass valve in each
transmission which allows the tractor to be manually
pushed short distances. See the "Maintenance &
Adjustments" section later in this manual for instructions.
Lift Handle
The lift handle is located on the RH console to the right
of the operator's seat and is used to raise and lower the
mower deck used with the tractor. The deck can be set in
any of ten positions by depressing the top button on the
handle, moving the handle to the desired position, then
releasing the button. It may be necessary to push or pull
slightly on the handle to depress the button.
Deck Height Index Bracket
The deck height index brackets have ten index notches.
The cutting heights range from 1-1/2" to 4-1/2" with each
of the ten index notches representing an approximately
1/4" to 3/8" adjustment to the deck height.
After changing the cutting height of the deck, you must
check the position of the deck front gauge wheels. They
should be approximately ½-inch above the ground when
the tractor is on a smooth, flat surface such as a driveway.
Refer to "Maintenance & Adjustments" later in this manual
Fuel Fill Cap
The fuel fill cap is located at the rear of the RH console to
the right/rear of the seat.
Turn the fill cap approximately 1/4-1/2 turn and pull
upward to remove. Align the threads of the cap and fuel
tank fill neck, then push the cap downward on the tank
and turn clockwise until a ratcheting sound is heard to
indicate the cap is tight.
The level of fuel in the fuel tank can be viewed through the
fuel level window in the rear hitch plate.
18 S 4— C
ECTION ONTROLS AND
F
EATURES
Cup Holder
The tractor's cup holder is located on the fender to the left
of the seat.
Engine Hood Retainer Strap
The engine hood retainer strap is located behind the seat
and is used to hold the engine hood closed.
To open the hood, grasp the upper end of the strap and
pull upward and forward to disengage the hood pin. Refer
to Figure 3-6. Lift the front of the engine hood and pivot
rearward.
Transmission Oil Expansion Tank
The transmission oil expansion tank is connected by hoses
to the RH and LH transmission assemblies, and is located
beneath the seat. The function of the tank is to hold the
natural expansion of transmission oil that occurs as the
transmission warms up during operation. DO NOT FILL THE
TANK.
Under normal operating conditions, no oil should be
added to the reservoir. The COLD oil level should be no
higher than approximately 1/4" (the "Full Cold" mark)
above the bottom of the reservoir.
NOTE: Prior to the initial operation of the tractor, the oil level
in the reservoir may be slightly higher than the maximum due
to air in the oil lines. Operation of the tractor will eventually
purge the air from the lines and the oil level will settle to the
maximum.
Seat Adjustment Lever
The seat adjustment lever is at the front/right of the seat.
Use this lever to adjust the seat forward or rearward to a
comfortable operating position. See the "Maintenance &
Adjustments" section later in this manual for instructions.