Cub Cadet 3000 Series Service Manual page 41

Cub Cadet 3000
Shown here is the correct orientation of the
spool/sleeve centering springs. Two sets of (3) each
curved springs in the center and (1) each flat piece on
the outside.
Figure 29.
To install the centering springs on the spool, first
install the two flat pieces.
Figure 30.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Next install one set of the 3 curved centering springs
between the two flat pieces.
Figure 31.
Then install the final set of 3 curved centering springs
between the flat piece and the previously installed
curved centering springs.
NOTE: The bowed side of the two sets of 3 centering
springs must point toward each other.
Figure 32.
6 - 8