Reassemble The Transmission To The Unit In The Reverse Order Above - Cub Cadet 3000 Series Service Manual

Cub Cadet 3000
17. Brace the transmission.
18. Remove all four of the front transmission support
bracket to frame hex cap screws and hex flange
lock nuts using a 9/16 wrench and a 9/16 socket.
See figure 5.
NOTE: The differential lock cable retainer bracket
is removed along with the transmission support
bracket.
Neutral Return
Spring
Transmission
Support
Bracket
Front
Transmission
Support
Screws
FIGURE 5.
19. Remove the "Z" fitting from the differential lock
actuator arm. See figure 6.
Cable
Retainer
Bracket
Differential Lock
Actuator Arm
FIGURE 6.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
20. Remove both transmission to frame "U" bolts
Lock Nut
Flat Washer
Hex Flange
Lock Nut
FIGURE 7.
21. Lower the transmission from the unit.
"Z" Fitting
Differential
Lock Cable
FIGURE 8.
REASSEMBLE THE TRANSMISSION TO THE UNIT
IN THE REVERSE ORDER ABOVE.
13 - 2
using a 3/4" socket. See figure 7.
NOTE: The "U" bolts have a lower point on one
side. The point goes towards the rear of the unit
during reassembly. See figure 7.
Front of Tractor
Lower
Point
NOTE: Be certain that the rear control rod is
removed from the hydro neutral return plate as
the transmission is removed. Also, make certain
the brake levers clear the frame.
Brake
Assembly
"U"
Oil Fill
Washers
Bolt
Tube
Elastic
Lock Nuts
Support Plate
Elongated
Slot
Fan
Charge
Pump
Brake
Assembly
Washers "U"
Bolt
Support Plate