Reassemble The Hydraulic Steering Pump In The Reverse Order - Cub Cadet 3000 Series Service Manual

Cub Cadet 3000
10. Remove the hydraulic tubes from the hydraulic
steering pump.
NOTE: If the hydraulic tubes do not want to come
out, use a small mallet and tap them out of the
ports. Be careful not to damage the tubes.
11. Inspect the "O" rings on the connectors for
damage. If damaged, replace.
NOTE: Place a small amount of grease on the
"O" rings and cover the connector surface
completely for reinstallation.
"O" Rings
FIGURE 5.
12. Support the hydraulic steering pump from below.
See figure 6.
13. Remove the four hex cap screws securing the
hydraulic steering pump to the frame using a
10mm wrench. See figure 6.
FIGURE 6.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
14. Remove the hydraulic steering pump from the
FIGURE 7.
Refer to the 1998 Cub Cadet Technical Update
Seminar manual for inspection and repair of the Char-
Lynn 2 series Steering Control in Section 17.
REASSEMBLE THE HYDRAULIC STEERING PUMP
IN THE REVERSE ORDER.
Hex Cap
Screws
Steering
Pump
10 - 2
tractor.
Auxiliary
Return
Steering
Steering
Main Pressure