Cub Cadet 3000 Series Service Manual page 44

Lubricate and install the o-ring seal into the groove
located in the wear plate.
Figure 41.
Install the drive, making sure you fully engage the slot
on end of drive with the cross pin in the spool/sleeve
assembly.
Figure 42.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Lubricate and install both the gerotor star and outer
ring. Install by aligning the splines of the star with the
drive. After installation, rotate the gerotors outer ring
to align with the housing cap screw holes.
NOTE: The grooved side of both gerotor star and
outer ring must face upward.
Figure 43.
Install drive spacer in gerotor star.
Figure 44.
6 - 11
Cub Cadet 3000