Exporting Test Luns; Defining Hosts - HP 3PAR StoreServ 7200 2-node Service Manual

Adding <static.ip.address> to firewall rules on interface eth0
5. Enter a valid user credentials (CLI super-user name and password) to add the HP 3PAR InServ
and press Enter.
Please enter valid Customer Credentials (CLI super-user name and password) to add
the HP 3PAR InServ.
Username:<Valid Username>
Password:<Valid Password>
NOTE:
version for compatibility. Update the SP with the proper InForm OS version before adding
additional systems.
6. After successfully adding the system, press Enter to return to the SP menu.
...
Starting 'spcollect' tasks for InServ <InServ Name>
Starting 'spevent' task for InServ <InServ Name>
InServ add complete
Press <enter/return> to continue

Exporting Test LUNs

As the final step in verifying the storage system installation, create two or three test LUNs and
confirm that the attached host or hosts can access them. After you have created the test LUNs and
verified that the host can access them, notify the system administrator that the storage system is
ready for use.
NOTE: Before you can export test LUNs, you must determine the host Fibre Channel connection
types and set the appropriate port personas for all target ports, or ports that connect to host
computers. See the HP 3PAR Implementation Guides where appropriate.

Defining Hosts

In order to define hosts and set port personas, you must access the CLI. For more information about
the commands used in this section, see the HP 3PAR OS Command Line Interface Reference.
To set the personas for ports connecting to host computers:
If adding a storage system fails, exit from the process and check the SP software
validating communication with <static.ip.address>...
site key ok
interrogating <static.ip.address> for version number...
Version 3.1.x.GA-x reported on <static.ip.address>
retrieving system data for <static.ip.address> ...
HP 3PAR system name <InServ Name> found for <static.ip.address>
SYSID <InServ Name> found for <static.ip.address>
serial number <InServ serial #>found for <static.ip.address>
Writing configuration file for <static.ip.address>...
verifying / adding cli service ids...
Adding InServ to NTP configuration...
creating required file structures...
Config complete for <static.ip.address>..
adding InServ to SP database...
Exporting Test LUNs 51