HP 3PAR StoreServ 7200 2-node Service Manual page 22

Typically the State is listed as Loss sync, the Mode as Initiator and the Connected
Device Type as Free.
3. Verify that the SFP has been successfully replaced by refreshing the above pane.
State should now be listed as Ready, the Mode as Target and the Connected Device Type
as Host.
To perform maintenance using CLI, access SPMAINT:
1. In the 3PAR Service Processor Menu, select option 7 Interactive CLI for an InServ.
2. Issue the following commands:
showport to view the port State:
s750 cli%showport
N:S:P
Label Partner FailoverState
0:0:1 initiator
-
0:0:2 initiator
-
0:1:1
-
0:1:2
-
0:2:1
-
0:2:2
22 Servicing the Storage System
Mode State
ready 50002ACFF70185A6 50002AC0010185A6 disk
- -
ready 50002ACFF70185A6 50002AC0020185A6 disk
- -
target ready 2FF70002AC0185A6 20110002AC0185A6 host
- -
target ready 2FF70002AC0185A6 20120002AC0185A6 host
- -
target loss_sync
- -
target loss_sync
Node_WWN Port_WWN/HW_Addr Type Protocol
- 2C27D75301F6
- 2C27D75301F2
SAS
SAS
FC
FC
iscsi iSCSI
iscsi iSCSI