Show Ip Dhcp Relay - Dell PowerEdge M420 Reference Manual

UDP Port
Discard
Hit Count
Server Address
Example
show ip helper-address
IP helper is enabled
Interface UDP Port
---------------
vlan 100
vlan 101
any

show ip dhcp relay

Use the show ip dhcp relay command in User EXEC mode to display the
BootP/DHCP Relay information.
Syntax
show ip dhcp relay
Parameter Description
This command has no arguments or keywords.
The relay configuration is applied to packets whose destination
UDP port is this port. Entries whose UDP port is identified as
"any" are applied to packets with the destination UDP ports listed
in Table 47-1.
If "Yes", packets arriving on the given interface with the given
destination UDP port are discarded rather than relayed. Discard
entries are used to override global IP helper address entries which
otherwise might apply to a packet.
The number of times the IP helper entry has been used to relay or
discard a packet.
The IPv4 address of the server to which packets are relayed.
Discard
-----------
dhcp
any
dhcp
Hit Count
-------- ----------
No
Yes
No
IP Helper/DHCP Relay Commands
Server Address
---------------
10 10.100.1.254
10.100.2.254
2
0 10.200.1.254
911