Dell PowerVault MD3620f Command Line Interface Manual page 40

Table 2-4. Recurring Syntax Elements
Recurring Syntax
nvsram-offset
host-type
nvsram-byte-setting
nvsram-bit-setting
ipv4-address
ipv6-address
autoconfigure-vols-attr-value-list
autoconfigure-vols-attr-value-pair
40
About the Script Commands
(continued)
Syntax Value
hexadecimal-literal
string-literal | integer-literal
nvsram-value
(0x hexadecimal | integer-literal)
nvsram-mask, nvsram-value
(0x hexadecimal, 0x hexadecimal |
integer-literal)
(0–255).(0–255).(0–255).(0–255)
(0-FFFF):(0-FFFF):(0-FFFF):
(0-FFFF):(0-FFFF):(0-FFFF):
(0-FFFF):(0-FFF)
autoconfigure-vols-attr-value-pair
{autoconfigure-vols-attr-value-pair}
physicalDiskType=physical disk-type|
raidLevel=raid-level |
diskGroupWidth=integer-literal |
diskGroupCount=integer-literal |
virtualDisksPerGroupCount=integer-
literal|
hotSpareCount=integer-literal |
segmentSize=segment-size-spec
NOTE:
physicalDiskType
The
not required if only one type of physical
disk is in the storage array. If you use the
physicalDiskType
also use the
diskGroupWidth
physicalDiskType
use the
configuration defaults to SAS physical
disks.
NOTE:
virtualDisksPerGroupCount
The
parameter is the number of equal-
capacity virtual disks per disk group.
parameter is
parameter, you must
hotSpareCount
and
parameters. If you do not
parameter, the