remotePassword
syncPriority
autoResync
writeOrder
writeMode
Notes:
Names can be any combination of alphanumeric characters, hyphens, and
underscores. Names can have a maximum of 30 characters.
When the primary virtual disk and the secondary virtual disk are chosen, the
secondary virtual disk must be of equal or greater size than the primary virtual
disk. The RAID level of the secondary virtual disk does not have to be the
same as the primary virtual disk.
174
Script Commands
The password for the remote storage array. Use this
parameter when the remote storage array is password
protected. Enclose the password in double quotation
marks (" ").
The priority that full synchronization has relative to
host I/O activity. Valid values are highest, high,
medium, low, or lowest.
The settings for automatic resynchronization
between the primary virtual disks and the secondary
virtual disks of a remote replication pair. This
parameter has these values:
• enabled—Automatic resynchronization is turned
on. You do not need to do anything further to
resynchronize the primary virtual disk and the
secondary virtual disk.
• disabled—Automatic resynchronization is
turned off. To resynchronize the primary virtual
disk and the secondary virtual disk, you must run
the resume remoteReplication command.
The write order for data transmission between the
primary virtual disk and the secondary virtual disk.
Valid values are preserved or notPreserved.
How the primary virtual disk writes to the secondary
virtual disk. Valid values are synchronous or
asynchronous.