Yamaha DM1000 Owner's Manual page 70

70
Chapter 6—Input Channels
E
Meters
These meters indicate the signal levels of the currently-selected Input Channel and its
available pair partner.
F
You can reverse the signal phase of the currently-selected Input Channel. (See page 60
for more information.)
G
DELAY section
This section enables you to set the currently-selected channel's Delay function. (See
page 61 for more information.)
H
PAIR section
This section indicates whether or not channels are paired. The heart icon (
piece when channels are paired. The heart icon is broken (
paired. (See page 73 for more information.)
■ Viewing the Pan, Fader, and Aux Send Level Settings
To display the View | Fader page of a certain Input Channel, use the corresponding [SEL]
button or fader to select the desired channel, then press the DISPLAY ACCESS [VIEW] but-
ton, then the [F2] button.
Move the cursor to a parameter you wish to change, then rotate the Parameter wheel or
press the [INC]/[DEC] buttons to modify the setting.
A
PAN/ON/Fader section
• PAN control.................. This control adjusts the currently-selected Input Channel's Pan
• ON/OFF button ........... This button turns on or off the currently-selected Input Chan-
• Fader.............................. This parameter sets the fader position of the currently-selected
B
SURROUND PAN section
• SURROUND PAN ....... The Surround pan parameters for the currently-selected Input
DM1000—Owner's Manual
(Phase) section
1 2
parameter.
Press the [ENTER] button to reset the Pan control to Center.
nel.
Input Channel. The fader knob is highlighted when the fader is
set to 0.0 dB.
Press the [ENTER] button to reset the Fader to 0.0 dB.
Channel are displayed only when a Surround mode is selected.
See page 121 for more information on Surround pan.
3 4
) is in one
) when channels are not
5
6