100
Chapter 8—Aux Sends
Viewing Aux Send Settings for Multiple Channels
You can view and set parameters for all Aux Send 1–8, including setting levels and Pre/Post
parameters.
This is convenient when you wish to visually check all Aux Send settings or simultaneously
adjust the levels of certain channels routed to Aux 1–8.
1 Press the AUX SELECT [DISPLAY] button repeatedly until the page listed
below that contains the desired channels appears.
- View1–16 page
This page displays the Aux Send levels of Input Channels 1–16.
- View17–32 page
This page displays the Aux Send levels of Input Channels 17–32.
- View33–48 page
This page displays the Aux Send levels of Input Channels 33–48.
These pages display the source Input channels and the corresponding Aux Sends in a
matrix. The parameters on these three pages (and the procedure for setting them) are the
same.
A
DISPLAY
Use the following buttons to display the desired parameters.
• LEVEL ........................... Select the LEVEL button to display Send level bar graphs for
• PRE/POST .................... Select the PRE/POST button to display signal source points for
B
FIX/VARI
These buttons indicate the Aux mode (Fixed or Variable) for Aux Out 1–8 and are only
for display purposes.
C
LEVEL
This field displays in dB the level of the Aux Send currently-selected by the cursor.
2 Move the cursor to either the DISPLAY LEVEL or PRE/POST button and press
[ENTER] to display the Level or Pre/Post parameters.
DM1000—Owner's Manual
2
Input Channels routed to Aux 1–8.
Input Channels routed to Aux 1–8.
1
3