Setting The Input Channels From The Display - Yamaha DM1000 Owner's Manual

60
Chapter 6—Input Channels
• PAN
This section enables you to adjust the pan setting of the signals routed from the Input Chan-
nels to the Stereo Bus. You can also apply the pan setting to a pair of Bus channels.
If the internal Surround Sound setting is activated, the Surround Pan settings for 3-1, 5.1,
and 6.1 channels are available (see page 121).
• AUX (Aux Send level)
This section enables you to adjust the level of signals routed to Aux Out 1–8. The signals can
be routed to Aux Sends from either the pre-fader or post-fader position.
• INSERT
This section enables you to patch input signals to external devices via the on-board I/O con-
nectors or I/O cards, or insert the internal effect processors.
• METER
This section enables you to switch the metering position of the signal levels that are dis-
played in the Meter page or on the optional MB1000 Meter Bridge. (See page 37 for more
information on selecting the metering position.)
Tip: You can store these channel parameter settings in the Channel library. You can also store
the Gate, Compressor, and EQ parameter settings to the corresponding libraries.

Setting the Input Channels from the Display

To set the Input Channel parameters, you can either move the cursor to the desired param-
eter on the display and change the value, or operate the desired button or control on the top
panel to directly change the setting.
This section explains how to set the parameters via the display.
Switching the Signal Phase
To switch the phase of each Input Channel, press the [
edly until the following
Move the cursor to the NOR/REV button of the channel for which you want to change the
phase, then press the [ENTER] or [INC]/[DEC] buttons to change the setting.
A
NOR/REV
These buttons switch the corresponding Input Channel phase. NOR buttons indicate
normal phase, and REV buttons indicate reversed phase.
DM1000—Owner's Manual
/INS/DLY | Phase page appears.
1
/INSERT/DELAY] button repeat-
2