Yamaha DM1000 Owner's Manual page 209

6 Select ProTools (as the target device) for the Target parameter (
in the upper-right corner of the page.
By default, Remote Layer 1 target is set to ProTools. If another target has been selected,
rotate the Parameter wheel to select ProTools.
7 Press the LAYER [REMOTE 1] button.
Remote Layer 1 is now available for control, enabling you to remotely control Pro Tools.
Note: When the Pro Tools Remote Layer is selected, the DM1000's top panel faders, Encoders
and other channel buttons control Pro Tools. To control the DM1000, you need to select an
Input Channel layer or the Master layer.
Tip:
• If an optional MB1000 Peak Meter Bridge is installed, Pro Tools channel levels are displayed
on the MB1000 meters.
• Pressing the [REMOTE 2] button and setting the TARGET parameter to ProTools enables
you to control Pro Tools from the Remote Layer 2. In this case, the Remote Layer 1 Target
parameter is automatically set to No Assign.
Pro Tools Remote Layer
2
) located
DM1000—Owner's Manual
209
17