Yamaha DM1000 Owner's Manual page 267

4 Assign the Bus signals to the slot channels that are used for the cascade con-
nection.
The following signals are available:
Options
CAS BUS1–BUS8
CAS AUX1–AUX8
CAS ST-L, CAS ST-R
CASSOLOL, CASSOLOR
The following display page is an example of integrating Bus 1–8, Aux Send 1–4, Stereo Bus,
and Solo Bus signals via two 8-channel digital I/O cards (such as MY8-AT).
Tip: Patching may vary depending on the type and number of buses used for the cascade con-
nection.
Note: Since the number of channels available on the digital I/O cards is limited, only Aux
Sends 1–4 are cascaded in this example. Using a 16-channel digital I/O card (such as
MY16-AT) enables you to cascade all buses.
5 On the master unit, press the DISPLAY ACCESS [INPUT PATCH] button
repeatedly until the In Patch | Cascade In page appears.
6 Select the Input Channels on the master unit to which the Bus signals are
input from the Slave unit.
The following display page is an example of receiving the slave unit's Bus 1–8, Aux Send 1–4,
Stereo Bus, and Solo Bus signals via two 8-channel digital I/O cards (such as MY8-AT).
Note: Be sure to patch the slave Bus signals to the same Buses on the master unit. Incorrect
patching will result in an incorrect cascade connection.
Description
Bus 1–8 Cascade Outs
Aux Bus 1–8 Cascade Outs
Stereo Bus L & R Cascade Outs
Solo Bus L & R Cascade Outs
267
Cascading Consoles
DM1000—Owner's Manual
19