Wire Harness; Cable Tie - Toro 135-6822 Installation Instructions Manual

Removing the Wire Harness from
the Handlebar
1. Remove the push-in harness clip securing the
harness to the spring bracket
Figure 14
1. Cable ties
2. Push-in harness clip
2. Remove the 2 cable ties that secure the wire
harness to lower handle-bar tube
3. Remove the 2 socket connector of the wire
harness from the bail switch
(Figure 14).
g289209
g289147
3. Spring bracket
(Figure 14).
(Figure 15).
1. 2 socket connector of the

wire harness

2. Push-in harness clip
4. Remove the push-in harness clip that secure the
wire harness to the switch bracket of the handle
bar (Figure 15).
5. Remove the wire harness from the machine
(Figure 16).
Note:
Discard the old wire harness.
Installing the CE Wire Harness at
the Handlebar
1. Plug the 2 socket connector of the CE wire
harness into the bail switch
Note:
The connector for the bail switch is at
the end of the harness furthest from the other
connectors.
8
Figure 15
3. Bail switch
4. Switch bracket
Figure 16
(Figure 17).
g289139
g289144