Table of Contents
Advertisement
3
Replacing the Wire Harness
Parts needed for this procedure:
1
Wire harness
2
Cable tie
1
Edge clip/cable tie
Removing the Wire Harness from
the Chassis
1.
Remove the 2-socket connector for the machine
wire harness from the 2-pin connector of the
voltage-regulator harness
1. 2-pin connector
(voltage-regulator
harness)
2.
Remove the flange-head bolt that secures the
ring terminal of the wire harness to the engine,
and separate the ring terminal
(Figure
1).
Figure 9
2. 2-socket (machine wire
harness)
(Figure
10).
1. Engine
2. Ring terminal (machine
wire harness)
3.
Remove the relay from the 5-socket connector
of the wire harness
Note:
Retain the relay for installation.
g289208
1. Relay
4.
Remove the flange head bolt and flange locknut
that secure the 5-socket connector of the wire
g289140
harness to the inboard belt guard
6
Figure 10
3. Flange-head bolt
(Figure
11).
Figure 11
2. 5-socket connector (wire
harness)
(Figure
g289268
g289142
12).
Advertisement
Table of Contents
