Table of Contents
Advertisement
Installing the CE Wire Harness at
the Inboard Belt Guard
1.
Insert the 2 push-in harness clips of the wire
harness into the 2 holes 6 mm (1/4 inch) in the
belt guard as shown in
Figure 20
1. Flange locknut
2. Belt guard (inboard)
3. Push-in harness clip
2.
Install the 5-socket connector of the wire
harness to the inboard belt guard
with the flange head bolt and flange locknut that
you removed in
Removing the Wire Harness
from the Chassis (page
3.
Insert the relay into the 5-socket connector of
the wire harness
Figure
20.
4. 5-socket connector
5. Flange-head bolt
(Figure
6).
(Figure
21).
1. Relay
g289208
4.
Assemble the edge clip/cable tie to the frame
plate as shown in
g289143
20)
1. Frame plate (base)
10
Figure 21
2. 5-socket connector (wire
harness)
Figure
23.
Figure 22
2. Edge clip/cable tie
g289142
g289441
Advertisement
Table of Contents
