2.
Adjust the control dial with a flat-blade
screwdriver.
The red pin indicates the diameter of the output beam.
• Do not turn the screw beyond the scale markings with an extra force. It may cause the product failure.
3.
Make sure that the O-ring is attached to the
joint part of the cover properly.
• If there are signs of deterioration or damage in the O-ring, replace it. Replacement O-rings (Set of gasket) are available
on request. For purchasing them, contact our sales agency.
4.
Reinstall the cover to the control dial.
Tightening torque for the cover should be 0.3 N・m or
less.
5.
Confirm the laser processing quality with the actual target object and fine tune the output beam
diameter, laser power and scanning speed.
• Use the ruler of the control dial as an adjustment guide. Repeat the adjustment and test lasing to set the appropriate
output beam diameter.
52
ME-VLW1N-SM-1