Panasonic VL-W1-N Series Setup And Maintenance Manual page 35

„ Rear
2
1
7
12
13
14
15
16
VL-W1500-N, VL-W1506-N
1. USB connector A (2 connectors)
This is the terminal for connecting the USB media or USB mouse.
For registering or saving data in the laser welding machine, connect a commercially available USB.
You can also connect a USB mouse when setting by using a commercially available monitor.
A USB port is also mounted on the front.
• Do not connect the USB devices other than a USB media or a USB mouse.
2. VGA connector: VGA OUT
This is the connector for connecting VGA OUT monitor. When using a separately sold console, connect the attached
return harness.
3. Reserved port
Do not connect any cable to this port.
4. Return connector: RETURN OUT
5. Console return connector: (VGA+RETURN)IN
Connectors for connecting the attached return harness for using console (option).
6. RS-232C connector: RS-232C
This is the connector for connecting to the external device so as to control the laser welding machine with RS-232C.
For details, refer to Serial Communication Command Guide.
7. Signal connector: SIGNAL
This is the terminal for communicating between head and controller. Connect the attached signal cable.
3
4
2
5
1
6
8 7
16
9
10
14
11
15
17
12
18
21
23
22
20
19
VL-W1A00-N, VL-W1A06-N
ME-VLW1N-SM-1
3
4
5
6
8
9
10
11
13
17
18
21
23
22
20
19
35